Do you know how to heat a customized Heat Shrinkable Sleeve with a heat gun?

Nowadays, more and more people use customized Heat Shrinkable Sleeve to protect cables, electronic wires and other products. They believe that using such products to protect cables is not only easy to operate, but also environmentally friendly! Most of the customized Heat Shrinkable Sleeve is made of radiation cross-linked polyolefin, which has excellent physical, chemical and electrical properties. The shrinkage ratio is 2:1 and 3:1, and some can even reach 6:1 and 8:1 or even higher shrinkage ratios. Its shrinkage temperature is generally between 80°C and 125°C.

As we all know, the customized Heat Shrinkable Sleeve has high requirements for temperature when shrinking. Normally, the temperature is 84°C. So, how to reduce it? Under normal circumstances, we use a heat gun to shrink because it is a very easy-to-use tool. Just look at the description name and you can operate it. It is similar to a hair dryer commonly used at home, and the heat gun is used as the main heat shrinking tool of the customized Heat Shrinkable Sleeve. For one, it is still very economical in terms of cost. So do you know the steps to use it? Let’s take a look at it with the editor below!
1. The heat gun adjusts the temperature button and press the switch.
2. Fine-tune the temperature button to heat the customized Heat Shrinkable Sleeve.
3. Move the hot air gun, change its angle, and heat it evenly.
In summary, the editor tells how to heat it with a heat gun. I hope you can learn more about it through the introduction of the above editor.